| 1. | If Both Sensors have not yet been Replaced, Both Sensors need to be Replaced now. If one Sensor has already been Replaced, only Replace the other Sensor. |
Note: You Must Turn OFF the Power to the System before Continuing. Defective Sensors can Not be Repaired, and Must be Replaced. Make sure the System Board is completely Dry before Turning the Power back ON.
| 2. | Remove and Replace the Defective Sensor or Sensors as necessary. |
| 3. | Plug the New Sensor or Sensors into the "SEN. A" Connector and "SEN. B" Connector on the System Board as necessary. |
| 4. | Make sure the System Board Sensor Connectors are Clean and Connected Properly. |
| 5. | Turn the Power to the System back ON. |
Not Sure Problem Corrected - Continue Test
Problem Found and Corrected - End Test
