Replace System Board

1.If the System Board has already been Replaced in a Previous Step, Select "System  Board Replaced Previously" Below.  If this is the first time, Continue to Step 2.

System Board Replaced Previously

2.If the System Board has Not been Previously Replaced, Turn OFF the Power to the System and Continue to the next step.
3.Remove and Replace the System Board with the Exact Same Part Number System Board.
4.Verify that All Dip Switches and, if applicable, all Configuration Setting Values are Set Correctly.
5.After the System is Powered back up, check for proper operation of all Control Panels and all Spa Equipment.
6.Exit this Test Sequence and Retest as Necessary.

System Board Now Replaced - Exit Test