BEFORE POWERING UP THE SYSTEM, Set The Dip Switches.
Identify the Default Configuration that most closely Matches the Plumbing and Equipment Installed.
Set the S2 Dip Switches 1, 2, and 3 on the System Board as Follows: (Switches 4-8 Must be OFF for all Configurations)
Dip Switch S2 is located to the Left of the Service Panel at the Edge of the System Board.
1. Pool & Spa Combination: Filter Pump, Heater, Pool Light, Spa Light, Auxiliary, and 2 Valve Actuators.
On Dip Switch S2, Set Switch 1-Off 2-On 3-Off
2. Pool Only: Filter Pump, Heater, Light, and Auxiliary.
On Dip Switch S2, Set Switch 1-Off 2-Off 3-Off
3. Pool & Spa are Separate Bodies of Water, Single-Plumbed: Filter Pump, Heater, Pool Light, Spa Light, Auxiliary, and 2 Valve Actuators.
On Dip Switch S2, Set Switch 1-Off 2-Off 3-On
4. Spa Only: Filter Pump, Heater, Light, and Auxiliary.
On Dip Switch S2, Set Switch 1-On 2-Off 3-Off
5. Pool & Spa Combination with a Spillover: Filter Pump, Heater, Pool Light, Spa Light, Auxiliary, and 2 Valve Actuators.
On Dip Switch S2, Set Switch 1-On 2-On 3-Off
Continue To Configuration Parameters