You must designate the Pool or Spa Equipment that you would like the Jets and the Aux Buttons to Operate from the Dolphin Remote.
Note: Other Buttons on the Dolphin Remote can be Programmed to operate CD Players, Stereo Receivers/Tuners, Stereo Amplifiers, and, Automotive and Marine Audio Systems. See the Dolphin Remote Operation Manual for Programming Codes and Instructions.
Before the Dolphin Remote can communicate with the Pool Control System, an Address has to be Assigned to the Dolphin Remote, and the Same Address has to be Assigned to the Pool Control System.
Choose one of the Remote Codes below to enter into the Dolphin Remote.
Remember the Corresponding Pool Address so that it can be Assigned to the Pool Control System later.
Remote Code Pool Address
0000 0 (no address)
0008 1
0080 2
0088 3
0800 4
0808 5
0880 6
0888 7
1. To enter the Remote Code into the Dolphin Remote, Press the Star Button Once, then Press and Hold the Setup Button until the Red LED Blinks Once and then Blinks Twice.
2. Enter the four digit Remote Code by Pressing the 0 and 8 Buttons. If the Remote Code is entered Correctly, the Red LED will Blink Twice.
3. The POOL LIGHT, SPA LIGHT, FILTER, and HEATER Buttons Cannot be Reassigned.
4. The JETS, AUX 1, AUX 2, and AUX 3 Buttons Can be Reassigned to Anything in the Device List or Scene List.
5. To Assign the Dolphin Remote Pool Address to the System and Reassign the Dolphin Remote Buttons, from the Display Screen on the Wireless Panel, Move Right to the Main Menu.
6. Scroll Down to Setup, and Move Right to the Setup Screen.
7. Scroll Down to the Bottom, and Continue Down to the Next Screen.
8. Scroll Down to Dolphin, and Move Right to the Dolphin Setup Screen.
9. Scroll Down to Dolphin Address to Assign the Dolphin Remote Pool Address to the System.
10. Press Select as necessary to display the Pool Address Number that corresponds to the Remote Code Previously Programmed in the Dolphin Remote.
11. Scroll Up to the Dolphin Remote Button that you want to Assign a New Device or Scene to, and Move Right to the Dolphin Buttons Screen.
12. Scroll to the Device List or Scene List, and Move Right to Select a Device or Scene to Assign to the Selected Dolphin Remote Button.
13. Scroll Down to the Device for the Selected Button, and Press Select to Assign that Device to the Dolphin Remote Button.
14. Scroll Down to Another Dolphin Remote Button that you want to Assign a New Device or Scene to, or Move Left to Exit the Dolphin Setup Screen.
15. Move Left again to Exit the Setup Menu.
16. Move Left again to Exit the Main Menu.
Continue To Adding a Second Wireless Panel
Return To Panel Operation Index