Configuration Mode allows you Setup all your Equipment to Operate Correctly, and exactly the way You want it to.
Training the Panel Must be Completed, and the Correct Startup Dip Switch Settings must be Selected before Configuring the System.
1. To Configure the System, Move Switch S1 on the System Board to the SETUP Position. The System will enter Configuration Mode. Switch S1 is located to the Left of the Service Panel at the Edge of the System Board.
2. When Switch S1 is Moved from RUN to SETUP, the following occurs:
(a) The Relay Resets in the System Box, (b) The Service Panel Display will read Setup Mode, and (c) The Wireless Panel will Enter Configuration Mode and will momentarily show the Entered Config Mode, Wait Screen as it initializes for Configuration.
3. Verify that your Startup Dip Switch Settings are the Closest Match to your Equipment Configuration, and Press the Select Button.
4. If your Startup Dip Switch Settings are Correct, Scroll Down to Yes and Press the Select Button. Otherwise Scroll to No and Press Select to Exit Configuration Mode.
5. After Selecting Yes, Scroll Down the Setup Devices Screen to Select a Device to Setup.
Continue To Adding The Heater