1. After Configuration is Complete, Move Left to Exit Configuration Mode.
2. Scroll Down to Yes and Press the Select Button.
3. At the Prompt, Press the Select Button.
4. On the System Board, Move Switch S1 to the RUN Position. The System will Exit Configuration Mode. Switch S1 is located to the Left of the Service Panel at the Edge of the System Board.
5. The Panel Prompt will Momentarily Indicate a Panel Reset is in Progress.
6. After the Wireless Panel has Turned Off, Press and Hold the Select Button for 3 Seconds to Turn it Back On.
7. It will take a couple of minutes for the System to Initialize, then the System will be Operating Normally in Automatic Mode.
Continue To Wireless Panel Operation