The Heater Settings Must be Configured in order for the Heater to Operate.
1. From the Display Screen on the Wireless Panel, Move Right to the Main Menu.
2. Scroll Down to Heater, and Move Right to the Heater Setup Screen.
3. With Set Pool Temp Highlighted , Press Select to Set the Pool Temperature.
4. With the Pool Set Temperature Flashing, use the Up and Down Buttons to select the Pool Set Temperature. Then Press Select to Save and Exit Set Pool Temp.
5. Scroll Down to Set Spa Temp, and Press Select to Set the Spa Temperature.
6. With the Spa Set Temperature Flashing, use the Up and Down Buttons to select the Spa Set Temperature. Then Press Select to Save and Exit Set Spa Temp.
7. Scroll Down to Heater, and Press Select to Enable the Heater.
8. Scroll Down to Heat Pump, and Press Select to Enable Only if the Heater is a Heat Pump. Heat Pump Must be Set to Disable for any other type of Heater.
9. Scroll Down to Pool Mode Heat, and Press Select to Choose How you want the Heater to be Controlled when the Water Temperature is Below the Heater Set Temperature.
Select Manual if you want to Only Manually turn the heater On.
Select Heat in Filter if you want the Heater to Only turn On during the Filter Cycles.
Select Polling > if you want the Heater to operate Any time the Water Temperature Drops Below the Heater Set Temperature, based on the System Polling the Water Temperature Periodically. To Set the Polling Times, with Polling > Selected, Move Right to the Set Polling Screen.
10. With Start Time 1 Highlighted and the Hour Flashing. use the Up and Down Buttons to select the Polling Start Time Hour. Then Press Select to Save and Move to the Minutes.
11. With the Minutes Flashing, use the Up and Down Buttons to select the Minutes. Then Press Select to Save and Complete Start Time Setting.
12. Scroll Down to Stop Time 1, and Press Select to Set the Polling Stop Time.
13. With the Hour Flashing. use the Up and Down Buttons to select the Polling Stop Time Hour. Then Press Select to Save and Move to the Minutes.
14. With the Minutes Flashing, use the Up and Down Buttons to select the Minutes. Then Press Select to Save and Complete Stop Time Setting.
15. Scroll Down to Poll Interval, and Press Select to Choose How often the Polling will take place during the Polling Time Set..
16. With the Time Between Pools Flashing. use the Up and Down Buttons to select the Number of Hours Between Polls. Then Press Select to Save and Complete Poll Interval Setting.
17. Move Left to Exit Polling Settings.
18. Scroll Down to Spa Filter Heat on the Next Screen, and Press Select to Enable Heating in the Spa Filter Cycles. Then Move Left to Exit Heater Settings.
19. Move Left again to Exit the Main Menu.
Continue To Setting Display Preferences
Return To Panel Operation Index