This is One Of Two Options for Training the Wireless Gateway to Communicate with the Pool Control System.
Go To Train Using The Service Panel for the Other Option.
1. TO TRAIN THE WIRELESS GATEWAY: On the Wireless Panel, From the Display Screen, Move Right to the Main Menu.
2. Scroll Down to Setup, and Move Right to the Setup Screen.
3. Scroll Down to Wireless Setup, and Move Right to the Wireless Setup Screen.
4. Scroll Down to Add Device, and Press Select to Add the Wireless Gateway to the System.
5. A Message on the Wireless Panel Screen will Instruct you to Press Select on the Wireless Gateway to Add it to the Network. Select is the Train/Reset Button on the Wireless Gateway.
6. On the Wireless Gateway, Press and hold the Train/Reset Button for Three Seconds until the Status LED comes on in Orange, then Release the Button.
7. On the Wireless Gateway, The Status LED will Flash Red Rapidly for a few seconds to indicate the Completion of the Training Operation. If the Status LED Flashes Green the Wireless Gateway has been Successfully Added to the Pool’s Network, and it is Now Communicating with the Pool Control System.
8. On the Wireless Panel, a Message on the Screen will Indicate that the System Network is Training itself to Communicate with the Wireless Gateway, and Instruct you to Wait.. for completion.
9. When the Training is Complete, the Message will Change from Wait.. to Success. The Wireless Gateway should now be Communicating with the Pool Control System Network.
10. If the Status LED Stays ON Orange the Training Operation has Failed and Must be Repeated.
11. On the Wireless Panel, Move Left to Exit Wireless Setup and Return to the Setup Screen.
12. Move Left again to Exit the Setup Menu.
13. Move Left again to Exit the Main Menu.
Continue To Configuring the Gateway
Return To Adding The Wireless Gateway
Return To Adding Remote Management System