Chemistry High and Low Limits for each Sensor Reading have been Set by the Manufacturer. However, if you prefer different limits, you can change them as follows.
Note: If the Chemistry Sensor Reading is Outside the Set Limits, an Alert will Flash on the Main Screen.
1. From the Display Screen on the Wireless Panel, Move Right to the Main Menu.
2. Scroll Down to Chemistry, and Move Right to the Chemistry Screen.
3. With Set High pH Highlighted , Press Select to Change the HIGH pH Limit.
4. With the High pH Value Flashing. use the Up and Down Buttons to select the New pH High Limit Value. Then Press Select to Save.
5. Scroll Down to Set Low pH, and Press Select to Change the LOW pH Limit.
6. With the Low pH Value Flashing. use the Up and Down Buttons to select the New pH Low Limit Value. Then Press Select to Save.
7. Scroll Down to Set High ORP, and Press Select to Change the HIGH ORP Limit.
8. With the High ORP Value Flashing. use the Up and Down Buttons to select the New ORP High Limit Value. Then Press Select to Save.
9. Scroll Down to Set Low ORP, and Press Select to Change the LOW ORP Limit.
10. With the Low ORP Value Flashing. use the Up and Down Buttons to select the New ORP Low Limit Value. Then Press Select to Save.
11. Scroll Down to Set High TDS on the Next Screen, and Press Select to Change the HIGH TDS Limit. TDS is Total Dissolved Solids or the Level of Salt in your Pool Water
12. With the High TDS Value Flashing. use the Up and Down Buttons to select the New TDS High Limit Value. Then Press Select to Save.
13. Scroll Down to Set Low TDS, and Press Select to Change the LOW TDS Limit.
14. With the Low TDS Value Flashing. use the Up and Down Buttons to select the New TDS Low Limit Value. Then Press Select to Save.
15. If you have an Optional ECOmatic Chlorine Generator installed in your System, Scroll Down to Chlorine Gen., and Move Right to Setup the Chlorine Generator.
16. With Chlorine Gen. Highlighted , Press Select to Enable the Chlorine Generator.
17. Scroll Down to Set ORP Level, and Press Select to Change Controlled ORP Level. The ECOmatic Chlorine Generator will Automatically maintain the Selected ORP Level.
Note: In order for the System to Control the ORP Level, POC Control Must be set to On.
18. With the Controlled ORP Value Flashing. use the Up and Down Buttons to select the New ORP Controlled Value. Then Press Select to Save.
19. Scroll Down to Extend Filter, and Press Select to Enable Extended Filter Cycles as Necessary to maintain the Controlled ORP Level.
20. Scroll Down to POC Control, and Press Select to turn On POC Control. When POC Control is turned On, the ECOmatic Chlorine Generator will Automatically maintain the Selected ORP Level.
21. Move Left to Exit the Chemistry Screen.
22. Move Left again to Exit the Main Menu.
Continue To Checking Alerts
Return To Panel Operation Index