The IP Server Addressing Information stored in the Wireless Gateway can be Restored to its Original Factory Defaults by using the Gateway Train/Reset Button.
Note: This should only be done when Necessary as it can cause the Wireless Gateway to Lose Communication with the Server until the Proper Value is Reentered by using the Wireless Remote Management Gateway Home Page. See Configuring the Wireless Gateway for Additional Information.
1. On the Wireless Gateway, Press and Hold the Train/Reset Button for 30 Seconds. The Status LED will turn ON Orange, then Change from Orange to Red, and then go OFF. Release the Train/Reset Button after the Status LED goes OFF.
2. The Wireless Gateway IP Server Addressing Information has now been Set to its Original Factory Defaults.
Return To Configuring The Gateway
Return To Adding Remote Management System