This is One Of Two Options for Training the Wireless Gateway to Communicate with the Pool Control System.
Go To Train Using The Wireless Panel for the Other Option.
1. TO TRAIN THE WIRELESS GATEWAY: The System should be Powered Up. You will need to be standing in front of the System Box, within reach of the Service Panel inside the Box.
2. On the Service Panel in the System Box, Press the Network Button.
3. Use the Up and Down Buttons to Scroll to Add Device on the Service Panel Display.
4. On the Service Panel, with Add Device on the Display, Press the Select Button.
5. On the Wireless Gateway, Press and hold the Train/Reset Button for Three Seconds until the Status LED comes on in Orange, then Release the Button.
6. On the Wireless Gateway, The Status LED will Flash Red Rapidly for a few seconds to indicate the Completion of the Training Operation. If the Status LED Flashes Green the Wireless Gateway has been Successfully Added to the Pool’s Network, and it is Now Communicating with the Pool Control System.
7. On the Service Panel, Adding... OK will appear on the Display, and then the Display will revert back to Automatic Mode after a short time.
8. If the Status LED Stays ON Orange the Training Operation has Failed and Must be Repeated.
Continue To Configuring the Gateway
Return To Adding The Wireless Gateway
Return To Adding Remote Management System