Check for All of the following Conditions:
Note: You Must Turn OFF the Power to the System before Continuing. Defective Sensors can Not be Repaired, and Must be Replaced. Make sure the System Board is completely Dry before Turning the Power back ON.
|1.||Both Sensors are Properly Mounted at the Heater.|
|2.||Both Sensors are Fully Inserted into the Thermal Wells|
|3.||Sensor Wires do Not have Cracks or Damage.|
|4.||System Board Sensor Connectors are Clean and Connected Properly.|
|7.||Heat Related Pump Not Running.|
|8.||Heat Related Pump Not Primed.|
|9.||Circ System Misconfigured.|
Now Test for Sensor Sync
Do you want to Test for Correct Sensor Sync Now?