| 1. | Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. |
| 2. | Do Not touch Any Buttons on the Topside Panel. |
| 3. | For EL2000, 5000, & 8000: With "Pr" or "PRIMING MODE TAKES 4 MIN" Displayed on the Topside and No Buttons Pressed, are Any Pumps or Air Blower ON and Running? For EL1000: With "Pr" Displayed on the Topside and No Buttons Pressed, are Any Pumps or Air Blower Other than a Circ Pump ON and Running. If the Answer is Yes, Select "Equipment ON at Start of Priming Mode" Below. If Not, Continue to Step 4. |
Equipment ON at Start of Priming Mode
| 4. | Check for which Pump is Plumbed through the Heater. (Circ Pump or Pump 1 Low) |
Circ Pump Pump 1 Low
|