Switch Sensors at the System Board

1.If Both Sensors have been Replaced in a Previous Step, Select "Both Sensors Already Replace" Below.  If they have not been Replaced, Continue to Step 2.

Both Sensors Already Replaced

2.If the Sensors have already been Switched in a Previous Step, Select "Sensors Switched Previously" Below.  If this is the first time, Continue to Step 3.

Sensors Switched Previously

3.If the Sensors have Not been Previously Switched, Turn OFF the Power to the System and Continue to the next step.
4.At the System Board, Unplug Both Sensors from the "SEN. A" and "SEN. B" Connectors at the Bottom Edge of the System Board, keeping track of Which Sensor is Plugged Into Which Connector.
5.Switch the Connections by plugging the one that was plugged into "SEN. A" to "SEN. B", and the one that was plugged into "SEN. B" to "SEN. A".

SensorConnectorsSmF-Sw

Sensors Switched - Continue